home *** CD-ROM | disk | FTP | other *** search
- Path: combo.ganesha.com!peterk
- From: peterk@combo.ganesha.com (Dr. Peter Kittel)
- Subject: Re: New Press Release!
- Newsgroups: comp.sys.amiga.datacomm
- Reply-To: peterk@combo.ganesha.com
- References: <2937.6638T1404T1877@mozart.inet.co.th> <151144@cup.portal.com> <peterk.0m5l@combo.ganesha.com> <626.6665T785T1989@telepost.no>
- Message-ID: <peterk.0mly@combo.ganesha.com>
- Date: 10 Apr 96 00:03:09 MEZ
- Organization: Private Site
-
- In article <626.6665T785T1989@telepost.no> ulv1@telepost.no (Arnulf Nielsen) writes:
- >>>>>Dr. Peter Kittel <peterk@combo.ganesha.com> wrote:
- >>>>
- >>>>The box casing is two part, upper and lower, and you can insert a
- >>>>middle part. On the mainboard, there is an expansion connector which
- >>>>can take a daughter board or riser card which carries standard slots
- >>>>like Zorro, PCI, Amiga Video or the like. The more slots you put on
- > ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
- >>>>this daughter board, the higher the middle part will be. Thus it's
- >>>>an extremely flexible design.
- >
- >Would it be possible to make a slot that would accept A500 expansion-cards ?
-
- A bit difficult, as the A500 has narrower buses for data and addresses,
- but it should be possible with some glue logic.
-
- --
- Best Regards, Dr. Peter Kittel // Visit http://www.amiga.de
- Private Site in Frankfurt, Germany \X/ Email to: peterk@combo.ganesha.com
- Employed at AMIGA Technologies GmbH in Bensheim, Germany
-